table of an explosion

[lukaluk11]

Hello, everyone! I press that I am new in the forum and in the use of the proe....so help! I need to know how to display an explosive design on the table where I changed the positions in the axieme? When I amount the design exploded proe I care about the default explosive that creates him... I hope I've been clear! thanks to all

 

[maxopus]

discussion already faced, a few days ago ... look for.

 

[lukaluk11]

You could tell me the name of the discussion. . Thank you!

 

[uluwatu_74]

discussion already faced, a few days ago ... look for.

Carriage Carriage!!! :wink:

perhaps refers to this: http://www.cad3d.it/forum1/showthread.php?t=13296&highlight=esploso

 

[lukaluk11]

be un grande!!!:finger:

 

[maxopus]

You could tell me the name of the discussion. . Thank you!

Rule #1: in the forums writing in case it is equivalent to screaming... were you screaming or didn't do it on purpose? because I don't pay attention to the screamers.

Rule No. 2: If I wrote you "try search" it means that you would have just clicked on search, select the pro/engineer entry and attribute as a search word "exploded" and you would have exited exactly the discusion that kindly uluwatu linked you.

Rule # 3: As that discussion was resolved by the undersigned ... a thank you would not be sorry ... and I stop here

Carriage Carriage!!! :wink:

perhaps refers to this: http://www.cad3d.it/forum1/showthread.php?t=13296&highlight=esploso

are a very big carnage::biggrin:

 

[lukaluk11]

:bekle:grazie!