table: problem with folded sheet and then lined by a size with surface

[Atreiou]

I have a sheet with two folds, a fold with sketch of a few degrees and a flange of the edge to 90 degrees
I then trim the edges of the folded sheet with a cut with surface because it serves me a particular shape not easily replicable with my skills in sw

now in the table, in the view "flat recetition" the sheet is cut by the function "cut with surface" as if it was active also in the table, even in the 3d those parts of the sheet are not cut by that function

ideas?

 

[MassiVonWeizen]

Yes, a... attach the file

 

[Atreiou]

You're right
I add that the surface that performs the cutting of the sheet, is then hidden so that it does not see in the final axieme

 

[New Rider]

You're right
I add that the surface that performs the cutting of the sheet, is then hidden so that it does not see in the final axieme

hello but excuse you can't start from a folded elle profile as you want and then create basic flange tab?

 

[Atreiou]

I have to create a rectangular tub where the inner base after a short planar tract must climb into a pyramid with summit in the center.
once the 4 coils of sheet metal are united at the top of the pyramid (which will then be welded among them), like what I have attached, the difficulty for me lies in finding to attempts the fold angle to make so that the planar traits of the bottom of the tank are as close as possible between them
the difficulty lies in finding attempts to bend
then once found the exact fold angle and the plates coincide, the cut with a triangular surface that perfectly defines the 4 spikes seen in the plant, and that fit perfectly in the final axieme.