Sleepers
Guest
I have to insert threaded holes, where some electrical cable will be screwed.
the thread would be like pg[misura] (https://it.wikipedia.org/wiki/filettatura#filettatura_pg), I believe norm en 40430, but I do not find it in standard libraries (I also open the thread.xls file to check).
in the old messages in archive I see nothing about it; that you know there is something ready or should I create the table?
looking around I saw this document (pg thread was replaced by metric thread):https://t3.lappcdn.com/fileadmin/catalog/2016_it_pdf/t23_pressacavi.pdf and this page with the values of the various diameters:our planter says that they are still in use[misura], but maybe it's just their custom to identify them and then actually the thread is metric.
Thank you.
the thread would be like pg[misura] (https://it.wikipedia.org/wiki/filettatura#filettatura_pg), I believe norm en 40430, but I do not find it in standard libraries (I also open the thread.xls file to check).
in the old messages in archive I see nothing about it; that you know there is something ready or should I create the table?
looking around I saw this document (pg thread was replaced by metric thread):https://t3.lappcdn.com/fileadmin/catalog/2016_it_pdf/t23_pressacavi.pdf and this page with the values of the various diameters:our planter says that they are still in use[misura], but maybe it's just their custom to identify them and then actually the thread is metric.
Thank you.