table threads inventor 2011

[PRIORE]

Good evening.
I wanted to ask for information if possible: in the table of the inventor threads 2011 and previous rel. do not report the trait to incomplete threads, what autocad mechanical instead has always done.
since I have a client to whom I am doing the 2d tables starting from the realization of the 3d that imposes in his drawings the presence of this graphic trait, I kindly wanted to ask if someone knows a way to overcome this inconvenience.
currently the only solution I found is to create in the various views a sketch and project the geometries of the thread to insert the missing section; but it is extremely laborious and complex.:
I attach the examples of threads generated by mechanical 2011 and inventor 2011, in case I had not been clear.
Thank you.

 

[stefanobruno]

because I have a client... who imposes in his drawings the presence of this graphic trait...

Unfortunately I can't help you, of course it's just sticking to everything.
Does the rest of the drawings understand or stop at the end of the thread?

Bye and good luck.

 

[meccanicamg]

Good evening.
I wanted to ask for information if possible: in the table of the inventor threads 2011 and previous rel. do not report the trait to incomplete threads, what autocad mechanical instead has always done.
since I have a client to whom I am doing the 2d tables starting from the realization of the 3d that imposes in his drawings the presence of this graphic trait, I kindly wanted to ask if someone knows a way to overcome this inconvenience.
currently the only solution I found is to create in the various views a sketch and project the geometries of the thread to insert the missing section; but it is extremely laborious and complex.:
I attach the examples of threads generated by mechanical 2011 and inventor 2011, in case I had not been clear.
Thank you.

inventor unfortunately does not follow exactly the regulations (see representation according to old regulations of roughness and geometric tolerances year 2000 and following not active).

seeks legislation on filet representation. If the offending trait is not indispensable, make a copy and attach it to the technical report in which you expose the situation. you will also indicate that you will have to charge the extra time for his fist. Then see what he says.

I believe that many should make the brain work more and make less demands from capricious children :biggrin:

on all 3d modelers I think it is still a "common mistake", perhaps because it is not indispensable and weights the graphics.

 

[PRIORE]

I'll see if I can convince him, but I doubt it. Maybe I should give up the job!!
Thank you for answering me

 

[massimo.l]

There is no way to operate in styles. you can overcome the problem by creating a bevel on the thread but remains the problem at the end of threads.