table tolerances with shock

[SweptBlend]

Good morning to all,
do you know if in inventor (2011) there is a possibility to insert a table that bears the quotas tolerated in the drawing, with the deviation relative to the quota itself?

example :

nominal value tolerance sc.superiore sc.inferiore

30 h7 30.001 29.98
15 f8 14.974 14.947
. .
. .

Thank you in advance

 

[bertu]

It would interest me too! thank you!

 

[Ilario]

table I don't know, but if you put it directly in the quota, since that can be done, right?

 

[ninfh]

unless I'm lost among the updates (and if I'm lost.... it's good to hang myself in view of the hours lost to put the quotas manually....) you can't set a tolerance on the x;y quotas but at the most you can set the number of decimals, the only tolerances set in the table should be those inherent to the description column (recovering the quota automatically from the model by changing the table quota styles)

 

[SweptBlend]

found!!!!

is called autodesk fitslist (do a gooooooooogle search and you will find it ).
you install, and a table icon appears in the top ribbon of the drawing environment.
important note, it is necessary that the quotas to be inserted in the table only have the nominal value and the indication of tolerance ( 15 h7, 6.3 h13 and so, not the deviation )
clicking the table icon of fitlist, asks for a set of parameters, et voila'... recognizes the quotas to tolerate, and appears a table to be positioned, with the nominal values, upper deviation, lower deviation. . .

 

[bertu]

Thank you! Very useful!