Good evening, I wanted to ask how to autocad to make a tangent line to a circumference giving him the tangency angle and the length of the line? Thank you.
if it is not a specific problem of mechanical it is better to write in the section dui autocad which is most followed. do not open a new discussion, but possibly ask moderators to move this.
This is more trivial than you think.
drawings a vertical or horizontal straight of the desired length
selections, say in the middle point, and activate the dial snap
attaches the line to the circle dial (which corresponds to its tangency)
Launch the wheel command and select the center of the circle set the rotation angle
