tavolozza viste solid works

[SuperbirbA]

Hello everyone, I created a 3d view design and now I want to put it on the table.
every time I bring a view to the table m disappears from the palette of views.
there is no way to repopulate it automatically without rightly deleting the views already inserted. ?
Thank you. .

 

[meccanicamg]

Hello everyone, I created a 3d view design and now I want to put it on the table.
every time I bring a view to the table m disappears from the palette of views.
there is no way to repopulate it automatically without rightly deleting the views already inserted. ?
Thank you. .

the view palette does not disappear, it is always available to the right as in the insertion of the first view. If you want it to not be reduced, press the dot and stay open.

 

[SuperbirbA]

I explained badly.. .
not that the palette disappears, but the views I put in the drawing disappear. .
There's a way not to make those views disappear whenever I put them in. ?

 

[lustro]

with the model view button opens to the left the manager to select the basic 3d (and typically is what you are using), then going forward with the steps allows you to select the view you want (even one of those already present on the table, to be sure that it is that wanted to check preview) and then you take it to the table

I hope I've been clear enough

 

[erik.bo]

Hi.
I don't know if you still need it, maybe you've solved it, but if I don't remember badly if you're up to date, I'll show you all the views available.

 

[Mike1967]

Hello everyone, I created a 3d view design and now I want to put it on the table.
every time I bring a view to the table m disappears from the palette of views.
there is no way to repopulate it automatically without rightly deleting the views already inserted. ?
Thank you. .

make sure you don't have the design template with the change sheet active.