text scketch

[Nic65]

Good morning.

Is it possible to write a text in the scketch (nx7.5)?

Published: precise, a text for a sucessive extrusion.

 

[IPdesign]

Why not use the text command?
That's what I'm doing.

 

[Nic65]

hi ipdesign,
Meanwhile thank you for the answer.
I use the text command, my problem is that I have to hack on a plate about 200 particular positioning numbers and having to select the face of the plate every time I insert a new number becomes a little long. I put myself in planar, to select the positioning of the text I have to go on specific point --> point on face --> select the face --> give ok. there was the possibility to do it in sketch probably would consider the sketch plan already' as "face" by default and I should just click the point where to insert the number one below the atro. I don't know if I could explain myself well, I hope so. I'm just trying to earn some time

 

[beppino]

If I understood correctly...
the right command is (only) what ip says.

the sketch can be created for the positioning points of the engravings, and (if the face to be engraved is not in plan) the text will project it on the face itself.

but the character to be extruded cannot do it inside the sketch.

 

[Nic65]

Okay, thanks beppino:finger: