the fastest way to learn... .at least the basics

[K79]

hi to everyone are a little close, I have to learn at least the basics of inventor in the shortest possible time, I do not expect to succeed in doing extreme things today to tomorrow, I just have to understand the basics and procedures to arrive at the end of the project, then the finishing stage I take it in a second moment.

What do you recommend?? ? tutorials on youtube, manuals, guides, test and try again, some good soul that has a vademecum? ?

 

[gil]

Take a course. somewhere in Italy will definitely be starting an intensive inventor course.

Chiramente is a solution that between course cost and trsferta is a bit expensive, but surely it is the fastest.

 

[diegus]

guardati i filmati

 

[Alby189]

for a base, get the pruners, read it all from the beginning to the end of the furnace to the pc with open inventor and doing practical evidence of what you read, in the end you will know how to use inventor quite autonomously.
I did it in about a week, in the period when I changed work before entering the new company, just arrived here I was already autonomous enough.
depends on the basic knowledge you have on modeling and drawing in general, if you use other parametric modeling programs you would definitely benefit!
What version do you have to use?

 

[K79]

2012

...

... m auto answer alone to the question
" use examples of colleagues or found online and...... you know how to do it

after 1 day we say that I managed to create trees and gowns with quotas, holes, quarries, shading, material choice.

We say I'm satisfied.

Of course, I'm not going to do things right but they come out of the way of attempts, I think the forum can help me a lot about it.

you do not know how to use constraints and when to use them or how to speed up work but learn

 

[davide75]

take the pruners guide or the new techniques guide. books for the 2013 version are now available. cmq more slender and first learn, in the end inventor is not difficult to learn. As for constraints only experience will make you understand how to use them at best but to model it just use simple rules.
Always remember that if you think to make a piece that is symmetrical remember to bind it symmetrically. the trees always try to make them through the revolution.quota binds them or sketches with criterion so that if you have to change it you already know where to go to act.magari quotalo in function of where it is inserted in the assieme
all this in the perspective that if you have to change the piece when you are later in the modeling of the piece you already know where to go to act without perhaps to affect the later features.

 

[Oriano]

hi, as I did: lessons from a mechanical engineer who took an inventor course. cost : 50€ per lesson (about one hour and a half)
then buy yourself a manual.

Oriano.

 

[stefanobruno]

hi, as I did: lessons from a mechanical engineer who took an inventor course. cost : 50€ per lesson (about one hour and a half)
then buy yourself a manual.

Oriano.

Come on.

I hope you made the invoice, given the amount.


Hello, welcome.

 

[Oriano]

Excuse me stefano, I did

thanks, greetings