contepier
Guest
Hey, guys. I have a problem I can't get out of.
I put a picture of a view in which I left the double cover layer that I used for cutting walls. the walls were deliberately left "low" to better clarify the thing. the second photo shows the double frozen ground, and the insertions of elbow beams in c.a. which, however, as you can see, disappear (a portion of these) at where the ground has cut the wall. on the perimeter the beams should start to external wire of the pillars, while instead in correspondence of these (which fall into the thickness of the wall) this disappears... and all that I put in the head of the building, disappears without the top. If I lift the walls, I also disappear the tip.. I always talk about the beam aligned with the head wall.
Why?... how can I get the wall cut according to my needs... and then insert elements without them disappearing at the cuts? Thank you very much for the answers.
Pier.
I put a picture of a view in which I left the double cover layer that I used for cutting walls. the walls were deliberately left "low" to better clarify the thing. the second photo shows the double frozen ground, and the insertions of elbow beams in c.a. which, however, as you can see, disappear (a portion of these) at where the ground has cut the wall. on the perimeter the beams should start to external wire of the pillars, while instead in correspondence of these (which fall into the thickness of the wall) this disappears... and all that I put in the head of the building, disappears without the top. If I lift the walls, I also disappear the tip.. I always talk about the beam aligned with the head wall.
Why?... how can I get the wall cut according to my needs... and then insert elements without them disappearing at the cuts? Thank you very much for the answers.
Pier.