thread display

[TECNOMODEL]

Today it turns like this:

both in .ipt and in .idw does not display threads.

in .ipt I do not see them graphically, in .idw I do not see them represented in the view even if the quota gives it as threads.

Is there any option to flag that I may have lost?
because until last week it worked properly

 

[Zac69]

in the table you have to go to the display options when you put the view and tick thread. in the part is an option but I no longer remember where you are

 

[TECNOMODEL]

in the table you have to go to the display options when you put the view and tick thread. in the part is an option but I no longer remember where you are

Thanks, now it's back to working properly. Mah.

I had already checked that there was a check, but I can't find the option for the parts.