thread error of screws of the center contents

[dreampippi]

hi to everyone, I have a problem with the content center, inventor 2013.
from this afternoon when I load into a set a screw that has never been created (so I don't find it in the file folder center contents), it gives me error:

"updating the file of parts of the unsuccessful member. a problem occurred when setting the thread data. "

I do ok and a life comes out with an absurd thread. control the created part by opening it, control the processing instead of pointing the metric profile iso creates the screw with a thread type ansi metric profile.

we never touched the thread.xls file, I don't think that's the problem.. .

Has anyone happened yet?

Thank you in advance!
Daniele

 

[Ilario]

there was a similar problem a few years ago just on the threads of some components, I do not remember on which version, if 2013 or 2011 even, but I think there is a sp... always if the version is still supported on the autodesk site.. .

 

[bradipo666]

hi guys, I hang up the discussion.... I inventor pro 2015 and I did all the updates through "autodesk desktop app" but always comes out the same writing when I try to insert some components from the cc...
Help! !

 

[bradipo666]

Does anyone have a solution?? :frown:

 

[bradipo666]

https://knowledge.autodesk.com/it/support/inventor-products/troubleshooting/caas/sfdcarticles/sfdcarticles/ita/inventor-error-message-when-placing-member-with-thread-of-custom-content-center-family.htmlI found this but it's not very clear. . .