thread: how does a left-hand thread insert?

[alulecia]

Hello everyone,
are several days that I can't find a solution to this problem: I'm modeling a blinder in sw. two of its particulars, namely a threaded sleeve and an eye-catcher (uni 6058) have left-handed m14 threads.
I modeled both details though the tie is a unified component but I can't find the way to insert left-hand threads.
Does anyone have any suggestions?

Thank you all.

alessandro

 

[aldus]

I have already answered this question if you are in a hurry looking at the site otherwise as soon as I have a second I write to you I look for the answers.
However in a short time you have to invent a manual system because solid does not propose it automatically.
type with notes or similar systems.
Hi.

 

[alulecia]

I'm not in a hurry. I try to find the post, too, do you remember the title of the post? If you happen to find the references I willingly accept them.

Thank you very much

 

[aldus]

trapezoidal filetracing or leakage
testhttp://www.cad3d.it/forum1/showthread.php?t=36070&goto=newpost

I'm not in a hurry. I try to find the post, too, do you remember the title of the post? If you happen to find the references I willingly accept them.

Thank you very much

 

[alulecia]

ok thanks I try then to create a standard for left or limit threads I will model only the specific thread even because m14 I think it is a standard for if already very little used.

suggestions regarding the procedure for manual thread modeling are equally well accepted.

Thank you very much