tilted section line

[bagiolino]

Bye to all,
Can someone tell me if and how can I do to create a non-orthogular broken section line? ?
I attach an image to make you understand, in essence I would like to see the scale as if it were always seen in the prospectus, thus creating a section line that follows the course of the two ramps.
I hope to be clear!
Thank you all!

 

[Erikilrosso]

Interesting problem!
from that little experience I have, it seems to me that the section you can divide it into two segments, but they will remain parallel to each other through a simple lateral shift.

 

[gfrank]

it is not possible to partially rotate a section
revit works on floors (view)
the section, in fact, sets a plan (view).
to do what you want, you have to do two sections (two levels of view) with the pane that on one side, coincides for both at the intersection point (of the floors).
the two sections can be joined in the table so as to depict a unique representation

 

[bagiolino]

Thanks for the answer, I was afraid I had to do as you say...
Now I try and in case you have problems I'll be resentful!
Thanks again and good work!

 

[fraribre]

according to me by inserting from the plant a new prospect (which will be perpendicular to your inclined scale of x degrees) you can create the new section you ask.

 

[fraribre]

maybe I gave an incorrect answer, I didn't read the first request properly

Sorry!