tips for a new user!

[mercurio]

Bye to all,

so far I have always used autocad, but I would like to broaden my knowledge with a 3d as you must, I had thought of nx.

My question is this: what hopes do you have a self-taught? Are there valid training courses?

thanks to all and good Easter.

 

[paolo_go]

hi mercury, what I can tell you that by self-taught it is possible to learn and also well, I am an example, I started from the old v16 and now I am on nx5, before using unigraphics I used catia v4 and before still autocad.
often the courses usually give a general infarination but do not enter specific, and they cost a lot of money, then it always depends on what you have to do if you have to model a bolt or if you have to model a particular body shop of a car, certainly it takes years to take familiarity with the medium, you just have to get passionate and not lose heart, it is a nice product maybe one of the best on the market.
However, a minimum of mental elasticity is enough and maybe start copying a simple object and then switch to a more complex one.
then in any case here in this forum you will always find someone willing to help you and guide you.
hello and good luck
Palo

 

[mercurio]

thanks paolo, do you know where I can find valid guides/tutorials? I have looked for something, but little stuff: either I am infected, or I have not looked well!
One last thing: which program is more widespread at industrial level and therefore should you know?

 

[paolo_go]

Usually the manuals and tutorials are given to the courses, I don't have someone a little old about the v17 (in pdf), on the net you find something you just look good and in the right places (capish ammè) :wink:

 

[mercurio]

Thanks again paolo. one last thing, a laptop with processor series i, ram from 4 giga ddr3 and ati from 1 giga can have problems with nx, cat and beautiful company?

 

[dalleman]

Thanks again paolo. one last thing, a laptop with processor series i, ram from 4 giga ddr3 and ati from 1 giga can have problems with nx, cat and beautiful company?

try to check the certificate hardware table.
I don't know. .
http://support.ugs.com/online_library/certification/

ciao