together that doesn't allow me to move substantiated parts

[gazan]

Hello everyone,
in a group I happen that all the parts that have degrees of freedom dragging them do not move.

Does anyone have any idea what it might be?

Thank you

Gabriele
- - - updated - - - -I forgot, inventor 2011

 

[eugenesis]

then : you must have at least one fixed part, then there must be no errors related to constraints;
if you go to the application options , -> together -> enables compatibility analysis constraints and -> enables related constraints (which you will then remove. . ),
then do "recreate everything" what does it say??

 

[MauroM]

Are there any activity?

 

[gazan]

then : you must have at least one fixed part, then there must be no errors related to constraints;
if you go to the application options , -> together -> enables compatibility analysis constraints and -> enables related constraints (which you will then remove. . ),
then do "recreate everything" what does it say??

Hi.
everything done as you say, component fixed, enabled analysis, no adactivity, but it does not give me any error and however it does not allow me to move anything, extra if I do an analysis of the degrees of freedom and try to animate the degrees of freedom he makes me see that the detail can move as it should,
I think it's a nice mystery.

Thank you

 

[gazan]

I solved, there were two fixed pieces that going to remove the fixing gave an error in a bond that I then deleted, now I can move everything, the problem is that inventor did not highlight the error until the pieces were fixed.

thanks to everyone anyway