toolbox components not replaceable

[strudeldemele]

Good morning to all,
I put in sw2017 a toothed wheel configured with the toolbox, then I made changes (cut in revolution, bevels, extrusion) and saved and renamed.
now the axieme in which it is inserted me the charge always as from toolbox without my changes....know xè and how can I do to avoid this.
the only solution I have found so far has been exporting it and reinporting it

thanks for the help
Good day

 

[MassiVonWeizen]

How did you name it again? Where did you save her?
check file references in the axieme file menu> references

 

[strudeldemele]

Hi.
I built it with theutitlity si sw2017, when I realized that the two wheels were the same component but with diffferent configurations I saved two new files in the folder of the server used to the parts of this machine, while the wheels made with the toolbox had remained in the predetermined sw folder.
I replaced the toolbox with the new file, saved everything and every time I reopen the axieme I went to look for the component of the configured toolbox instead of the two separate files (with completely different name)
Now I solved by replacing as usual, then I deleted the file that disturbed me and, reopening the axieme fished the correct files alone without asking anything and continues to go all right.