tooth penetration dentate wheels

[vingal]

good evening to all, my problem concerns the simulation in kinematics of gear between toothed wheels, I can perfectly simulate the mechanism by means of the special bond toothed wheels, I only respond to a problem in the interconnection between in teeth, that is it is quite random and not what it must be, I have set a link between the two primitive circumferences. I would be very grateful if you could respond.thanks

 

[meccanicamg]

is the same problem that has solidworks, having the same module. does not hold the phase index even if it depends in part on the initial timing

 

[vingal]

understood but as I do to solve the problem, possible that no one has ever coupled two wheels in motion, I would be very grateful.thanks

 

[meccanicamg]

to tell the truth by getting the problem has never been so important. if I have to do a dynamic cinematic study with the appropriate form I leave with the plane constraints with the appropriate plan correctly. I don't know if your need is a point or a real need

 

[vingal]

mine is not a dot but it does not seem correct to me that the teeth are interconnected with each other.However, given my inexperience what you mean by plane constraints made correctly

 

[meccanicamg]

normally the gears obtained with kisssoft or traceparts have the first tooth or the bundled compartment with the main floor. if you pair the two floors of the two gears surely faded parts. in the dynamic or cinematic module suspend the bond and put the engine on the gear. having activated the contact between solids you will transmit with the real gears. Of course the profile must be done well, otherwise it is all another thing

 

[vingal]

you say that you put the link between the compartments, then lift this constraint and put a joint of dense wheels. If I am not mistaken I have already provided a solution like this but without good result, I think because the wheels I made for obvious necessity not being able to use those mentioned by you.

 

[meccanicamg]

then depends even if you use the spline or not.
you could try to parameterize rotation with the angle bond of the two wheels. technically you can but it is a ball to do it. However,

 

[vingal]

ok I try for the moment thank you