topological analysis together

[Ludo1996]

Good morning to all,
as from title I wanted to know if it was possible to do topological analysis of a set and not on the single part that composes it.
the problem is that by doing a topological analysis only on one part I don't know how to set loads/wins, since these are mainly applied to other system components. the software used is solidworks.
Thank you in advance.

 

[Zurtolo]

hi, if I didn't get it wrong you should do an analysis together and then use contact formulations between the various components. solidworks has functions for contact, but I have always struggled personally. if you can ideal it is to break down all the forces and loads and idealize the constraints of how to analyze the individual parts.