trailing zero / zero finals

[etc]

friendly users,
I have a small scratch with the final zeros in nx, modeling module.
In practice, I would like to use 3 decimal digits, but omit zeros.
Although I have tried any settling, nx does not seem to want to give me this satisfaction.

I also have the annoying (for me) problem that, if I have for example a quota of 10.46 mm.. the round at 10.5...

Can anyone clarify my ideas because I couldn't find anything online, and I looked a lot.

Thank you.

 

[ceschi1959]

friendly users,
I have a small scratch with the final zeros in nx, modeling module.
In practice, I would like to use 3 decimal digits, but omit zeros.
Although I have tried any settling, nx does not seem to want to give me this satisfaction.

I also have the annoying (for me) problem that, if I have for example a quota of 10.46 mm.. the round at 10.5...

Can anyone clarify my ideas because I couldn't find anything online, and I looked a lot.

Thank you.

if you talk about modeling you have to go on this panel and set the appropriate values.

Hi.

 

[etc]

I mean, when I create sketches for the various features.
if for example I have a quota of 6.035Why is it only 6.0?

_
I looked at the panel you told me, the settings are identical, I had already found someone, on other forums, pointing at the same panel but nothing changed.

I set the annotation settings as followsthe zero trailing option, disabled, should omit the final zeros.
3 decimal digits should also be shown.

the final zeros are not hidden and the odds are shown with excess rounding or defect.
6.035 becomes 6.0
There must be something I miss.
thanks for the reply cmq

 

[The_Matrix]

I have 3 decimals and the sketch odds are displayed correctly:
- 3 decimals in the case of "decimal" quota (80.777)
- 0 decimals in case of "exact" share
I have nx8.5.1 and nx9ph7

only thing I have seen is that if in the share of the sketch (let's say it's 200) I put:
- 200.
- 200.111: OK
- 200 : 200,000 is displayed, even if I turned off trailing zero

 

[ceschi1959]

Sorry I'm late in the answer, but I had a little full week. the set that is shown in the second image you set it in customer default or local?

 

[etc]

_
Good morning, no problem for the "priest", no delay!
the only place I could set those settings was in
customer default -> drafting -> general -> drafting standard
and in
Favorites -> annotations