variable curve offset

[Giacomanu]

Hello everyone,
I am drawing a profile that is composed of spline and I have to make an offset of this sketch (bedding curve control) but this offset must not be constant but in the initial part it must have a 5 mm offset and in the final one must be 8 mm, I would like to know if you always run with this command or there is one more specific one, because with this command I do not find what I need.

thanks for the help

 

[Primizio]

I'm sorry for brevity, but I have to get back to work.

I hope I've got the problem.

greetings

 

[Giacomanu]

Thank you so much for the answer, but I have nx 6 and I don't have this screen you show me.
Do you know if with nx 6 there is this function? ?

Hello and thank you

 

[Omen]

I think it was already in nx6.
insert-curve from the curve-offset

Hi.

 

[Giacomanu]

si in nx 6 this command exists, but it does not work in sketch environment, practically opens me the mask of "offset curve" and makes me do only the unique offset... I hope I've been clear.

Thanks for the help, we hope it's me who can't find the right command.
Hi.

 

[axa]

si in nx 6 this command exists, but it does not work in sketch environment, practically opens me the mask of "offset curve" and makes me do only the unique offset... I hope I've been clear.

Thanks for the help, we hope it's me who can't find the right command.
Hi.

That's right.
inside the sketch you can only do constant offsets, you have to exit the sketch and use the command

insert - curve from curve -offset.

Bye.

 

[Giacomanu]

Okay.

hello and thank you all