variable value in famili table

[DANI-3D]

Hello, everyone.
I've got a little bit of a problem. in a particular, whose variants I manage through ft, a quota comes from a calculation that I solve through relationships. when the result changes I must remember to manually change the value in the ft, and here I am very annoyed because I am never sure to have the updated data.
Is there the possibility of inserting directly into the ft cell, through parameters, reports etc., the result of the calculation?
thanks, greetings

 

[Parametric_Ozzy]

Hi, dani, let me understand... but the derived quota add it to the variable columns? you can add any quota or parameter "variable" in ft, you just have to make sure you do the verification variants on all the ft when you change something, proe recalculate on all the new result.
the classic example is of the weight: suppose on a ft of a m10 screw where you manage the variable lengths, add as variable parameter in ft the weight (which is managed by a relationship like you know) and launch the variants verification, that cell is a value that automatically returns you the program.

 

[DANI-3D]

Hello, Ozzy.
I'm sorry, in the meantime, I got a half idea to simplify things, even because I've been very busy. I clear my mind a little bit and then I reform the question.
Have patience.

 

[Parametric_Ozzy]

Hello, Ozzy.
I'm sorry, in the meantime, I got a half idea to simplify things, even because I've been very busy. I clear my mind a little bit and then I reform the question.
Have patience.

ahhaha the heat hurts... quiet the reality is very simple.:finger:

 

[DANI-3D]

ahhaha il caldo fa male...

Maybe it was just the heat... One could have hopes towards September.