LucaR83
Guest
Bye to all,
in the company we are trying to insert a verification tool of possible interference between screws and related threaded holes.
with the current models we have in archive, the global interferance command does not help as it detects all interference.. I saw that there was a trend that already spoke about it, but a bit dated (2011) ... I wanted to know if someone found a valid method for this verification.. the verification that most interests us is to go to analyze if a screw can be too long inside a passing hole with blind thread.
thanks for the support. .
Bye.
in the company we are trying to insert a verification tool of possible interference between screws and related threaded holes.
with the current models we have in archive, the global interferance command does not help as it detects all interference.. I saw that there was a trend that already spoke about it, but a bit dated (2011) ... I wanted to know if someone found a valid method for this verification.. the verification that most interests us is to go to analyze if a screw can be too long inside a passing hole with blind thread.
thanks for the support. .
Bye.