verification of threaded couplings

[exxon]

I am looking for a method to verify the correctness of screw-hole couplings in large sets.

when in an assembly there are hundreds of screws it is impossible to control them one by one to avoid that in the course of changes and updates you find yourself with a screw m5 coupled to a hole m4 or vice versa.

Is there an automatic function in inventor to carry out this task?

 

[Matteo Cappelli dis.CAD]

Hi.

If you use the "bucket connection" command with a single command, go from the inside of the axieme to perform the holes of the plates, insert the screw nut washer.
to change the hole everything updates avoiding successive controls

 

[exxon]

Thanks for the answer.

I haven't used that function yet. I'll put this on the "to-do" list. . .