water swimming pool

[orla91]

I have a problem: I created a small pool full of water and in the preview it comes out correct (as I would like) but then rendering the water practically you do not see. I don't know what to do anymore. Do you have any advice?

 

[render54]

I did a test.
in a pool I put a solid giving it water->pool material 140 cm, 315-35 or 65 is the inclination of the sun
I then modified the height of the solid bringing it from 0-140 to 139-140 therefore a cm thick.
the result is this
the person in rpc was put to see the refraction of the diversity of water thickness

 

[orla91]

Can it be a mistake to create a floor whose only material is water? because I don't know what to do anymore. It's like water's too transparent. .

 

[render54]

Can it be a mistake to create a floor whose only material is water? because I don't know what to do anymore. It's like water's too transparent. .

try remaking water as solid, you can vary the thickness more easily and see with which thickness the result you like most

 

[orla91]

I'm beginning to go crazy ahahah excuses ignorance how to create solid? I have always edited existing masses (such as floors or other)

 

[orla91]

Sorry the double post however I solved for the solid but always remains too transparent.. Can someone tell me that transparency use for water material? Maybe that's what I'm doing. .

 

[render54]

it must be taken into account that a swimming pool fills it with water network water and must be by force without suspended substances as it can be a lake or river and therefore transparent
I made a further test with thickness of solid water at 70 cm and 100 cm
and then one with camera height 170 cm from water fur

 

[render54]

I add this aerial photo to demonstrate the transparency of the water of a pool, notice the shadows of the edges on the pool bottom