welded board

[SE-Bologna]

Hello, everyone.
I have a welded assembly that has post-saving work.
I would like to make the tables of the details (ok) a table for the processing (ok) and a table with the only welded (without processing)
in the table of the asm (without processing) hid the features of assemblies in the views, **but also hides the welds** !!!

Did I miss something? How do I solve this?
Thank you.

 

[SE-Bologna]

excuse the up but it seems strange to manage the solid edge welded board.
somewhere I must have missed a ride.
Does anyone have experience of welded boards that are then processed?

Thank you.

 

[Be_on_edge]

I would do a set for welded and a set that contains welded and post welding work

 

[radio]

with this selection you can see welding but not the features of assemblies that remove material.

 

[Be_on_edge]

with this selection you can see welding but not the features of assemblies that remove material.
View attachment 71713

this option I had forgotten; especially for the horrible translation, do you remember what was previously called? If not I look at it in English and send a signal

 

[radio]

this option I had forgotten; especially for the horrible translation, do you remember what was previously called? If not I look at it in English and send a signal

Yes, yes, the translation doesn't mean anything. Unfortunately I don't remember if in the vers. previous was different.

 

[SE-Bologna]

Great, that's what I needed.
In fact, I didn't try to scourge not understanding the translation and an attempt I could even do it.
I usually install always in English but for this job I have to work on a machine on which I can't intervene.

Thank you!

 

[SE-Bologna]

if you make a signal it would be to be added that, if the welding is affected by the post-welded processing (complexing slices), in the pre-worked views it is shown as already worked and therefore missing pieces.

Hi.

 

[Be_on_edge]

I make a report for wrong translation, what you ask I think is a request for improvement that you should forward through your solid edge retailer