window on tilted wall

[andreapisetta]

I have seen some open discussions on this subject but not one that solves this problem.
I created a wall with the command creates extrusion and it turns out to me an external side not parallel to the inner side (old wall).
After creating the windows with the tilted bunches, putting them in the wall the gaps are generated as transparent, letting me see beyond the wall. Has anyone happened yet?

 

[gfrank]

Can you send the window family?

p.s. welcome to the forum

 

[andreapisetta]

I'm still finishing it, I can't make the bat match up above that goes to the window with the bat below. Anyway I'll send it to you so maybe you can do it all the time if you explain how to send it since the allega file doesn't leave me
Sorry I didn't show up....:wink:

 

[gfrank]

I'm still finishing it, I can't make the bat match up above that goes to the window with the bat below. Anyway I'll send it to you so maybe you can do it all the time if you explain how to send it since the allega file doesn't leave me
Sorry I didn't show up....:wink:

send it in compressed format . zip

 

[andreapisetta]

Here it is, modified in the bat, now it works, the only trap is the transparency of the vacuum on the project

 

[gfrank]

That's true.
I noticed that, after entering the window into the wall, if you draw the same gaps created by the window (the shoulders and the hole) directly into the wall (command: select wall> dynamic modification> empty) the transparencies disappear ....(? )
the edges of the voids that cross the wall, must be perfectly consistent with the gaps created by the window

perhaps recognizes the empty walls, as priority, then "fills" the faces generated by the vacuum, while the "faces" of the wall created by the voids contained in the family of the window considers them as "transparence", or "without faces"

 

[andreapisetta]

I tried to create the voids and the method works, but it is an adjoining to the problem, since I have 100 windows so in the mix and each varies for wall thickness and net width.
thanking some answers, I would like to know if someone has the logical explanation of the reason for the behavior of the window.. .