window options inventor prof 2012

[Nikipa]

hello to everyone together with a good day.
I still propose my problem if such is...
I have installed the above program and during its use, for an adequate learning, I have the following:
finetra options - document setting - do not appear in the middle of the same window the commands - ok ; apply ; deletes necessary I believe to change the parameters set in default.
I can't resize the same as the lower edge turns out to be off screen.
Is there a way to overcome the problem?
thanks for possible collaboration

 

[Christian76]

but what monitor resolution are you using?

 

[Nikipa]

Hello cristian and thank you for having responded

set screen resolution is 1366x768

 

[Christian76]

I think the windows you try to display have a minimum size bigger than your desktop resolution.
Can't set a higher resolution?

 

[Nikipa]

No, it's at most

 

[Christian76]

from the few information you gave me I think your pc is not suitable for using recent software.
I hope I'm wrong.
Hi.

 

[Nikipa]

should be the last generation exactly:
samsung
intel(r)core(tm) i7-2630 qm cpu 2 ghz
600 gbytes of memory
tab intel hd graphics

also reporting me to my previous report, i.e. the options tab
I also detect the following abnormal situation:
to change the default parameter, the finetra highlights the list of parameters, but it is placed on the last parameter in the list, unlike the one that would prefer.
also does not take into account any restoration if not closing and reopening the window.
all remaining programs installed 8 among the most recent) work perfectly.
do you think I should reinstall invento prof 2012, ?
Could this be the solution?
thank you for your kind collaboration

 

[Catafratto]

by curiosity I set on my monitor a resolution similar to your (1280x768) and neither could I see the buttons of the window, not even moving the lower bar of windows... looks like a screen resolution problem. I can tell you that anyway esc is equivalent to "nothing" and that following the change of some menu item you select "applies" as default key; or, make your changes and press blind and select "apps". After ... apply the "ok" button (which you do not see) turns into "close" and sending again you will exit the menu. for "import" from the general tab you can press tab 25 times to bring the selection to that key; 26 to take her to "export."
Good luck.

 

[Nikipa]

Hi, catafract, you were very courteous.

But is it really so complicated?

I see you see the commands in the middle of the window. How did you do that?

 

[Catafratto]

I display the commands using a "normal" resolution, with what you have to arrange as you can...