window references

[MISTERPRIMUS]

Hello everyone, I have a little inconvenient that alone I can not overcome:

I have the cessita when I perform a sketch to remakes (axles.....)
For example, I have to make a sweep like this:

sweep - sketch - select s plans - so I would like to open the reference window , so to choose other references (sometimes it opens automatically at times not)........nn I figured out how you act.

I hope I've been clear in my inquiry.

Thank you.

 

[maxopus]

when you are in sketch mode go to the sketch menu?

 

[MISTERPRIMUS]

but I do not see this window references.... I only visualize plan axes....
But I don't see it.

How do I do that? ? ?

 

[MISTERPRIMUS]

in practice this window should open when I press the sketch button of the reporting plan window............... .

I know how to explain better

 

[SweptBlend]

the reference window, opens in self-magic, within protusions and revolutions,
while in other features, and always inside the sketch, to activate/reactivate it,
in the sketch menu, there is the voice sketch | references
as well as suggested by maxopus

 

[maxopus]

In fact... this is the command to use when you enter sketch mode.

the window is not automatically activated because you can also decide to use an existing sketch, curve or corner.

 

[MISTERPRIMUS]

thanks solved thanks to the inserted image.
in fact in my view it did not appear in the skecth menu bar and quind I could not activate the referents.
Thanks for the help.