wizard transfer resources drawing

[spy280]

Here I am again...who can tell me what this error means (see image) , in an attempt to replace the new cartiglio, imported with "guided procedure transfer resources drawing". The transfer was successful, in fact, the same cartilage I imported, for some .idw it worked, for some not. I forgot, I use the 2010 version. hello and as usual, thanks to anyone who can answer me.

 

[ValvMax]

Here I am again...who can tell me what this error means (see image) , in an attempt to replace the new cartiglio, imported with "guided procedure transfer resources drawing". The transfer was successful, in fact, the same cartilage I imported, for some .idw it worked, for some not. I forgot, I use the 2010 version. hello and as usual, thanks to anyone who can answer me.

Hi. .
I think it could be constraints that you put into a sketch directly on the idw that for some reason if you changed the geometry of some component or the cartiglio itself maybe it can't reposition them and it gives you error...check the constraints if you applied them

 

[spy280]

hi, surely it is some constraint that bothers, but it is so messed up this cartilage, with an infinity of insertions, that I gave up to go into the background. At the moment, since the teaming is different from table 1 to table 2, I loaded the square of the 2 table, and then I glued from another table (functioning), the properties and inmissions required, on table 1.. in practice a big mess, but it was the only hurrying way to solve the problem, otherwise I should have handled everything in autocad.
it worked and so...:finger:
Thank you.