"wrap" written and logo on curved surface: how?

[reggio]

Hello, everyone!
I would like to get a 1mm relief of a text and logo sketched on a curved surface.. .

I have tried in some ways but I can't find a way to succeed, I lock myself in front of the selection of the affected surface (the blue one) and I can't find a command that can help me.

Is it possible for you? How? with which commands?

 

[MassiVonWeizen]

Can you tie a step?

 

[reggio]

Can you tie a step?

What changes you with step? question of different versions? me 2016
Here's the step!

 

[MassiVonWeizen]

What changes you with step? question of different versions? me 2016

I know you have 2016, you're one of the few who wrote it in the profile. I have 2014 and how you will know I cannot open future versions.
At least now I have a correct geometry on which to make some shy evidence

 

[MassiVonWeizen]

looking in the solidworks form I saw a winding on a curved surface that could be traceable to your situation, unfortunately I see it is a post of 2018 and this could mean that the function has been improved in the last versions; this debate https://forum.solidworks.com/thread/226672I also found this one that would seem to do in your case https://forum.solidworks.com/thread/65684

 

[reggio]

looking in the solidworks form I saw a winding on a curved surface that could be traceable to your situation, unfortunately I see it is a post of 2018 and this could mean that the function has been improved in the last versions; this debate https://forum.solidworks.com/thread/226672I also found this one that would seem to do in your case https://forum.solidworks.com/thread/65684

Thank you so much!
... and yet I remember that winding I had already used it successfully ... I do not remember where or if it was an exercise .. maybe of prampolini ... mah

boh, in the end I solved with cutting surface (these surfaces, they would really be to study and try well... )

 

[strudeldemele]

Hello
I happen the same thing with the writings or other to insert into printed pieces; an alternative solution is to create writing as solid.... create an offset surface of your parts (e.g. 2mm per part) .... cut off the extra part .... then remove what remains of the writing from your primary surface.
if you need you are on the network of vector fonts