xncdoku

[cimaguy]

hello to all

I installed version 9 of toptron.

as in the cam the report made with the command "xncdoku"

It doesn't work as in 8.5, but it writes the wrong data!, I ask everyone if

you have found the same problem or not.

Thank you.

 

[Dylan]

How does it not work anymore? Is there a new one? configurable?

What do you mean by wrong data?

I can't help you because I don't have 9, but that scares me already. .

Because you're a cam driver. What about the burning of news? What's good and what's wrong? (other than the report??

dylan

 

[cimaguy]

but, wrong in the sense that : the name of the program does not appear, the total working times do not correspond to those of the post and, to finish, fresh refreshment
He just broke up this morning and didn't leave anymore.

I'm still checking whether it's up to me or if it's just a program defect.

for news is still early to express itself (I installed it recently)
but I like shooting "I'm going to the side" that work
i.e. without breaking the vertical areas with the horizontal.

Hi.

 

[monster]

the total working times do not correspond to those of the post

normal.....multiplicated for three with high speed machine

He just broke up this morning and didn't leave anymore.

....normale :biggrin:

but I like shooting "I'm going to the side" that work
i.e. without breaking the vertical areas with the horizontal.

look as we are poor and we travel by camp... put some sewer:finger:

bye bye

 

[Dylan]

How did you solve the report?

dylan

 

[cimaguy]

Well,
in the end I had to leave xncdoku and I customized the one of

toptron in mht format.

I have to say that this is not very difficult, as long as you set variables

that you want to get out in the report.(In the online guide is explained a little how to do).

Hi.