heat up.

[slurpix]

Bye to all,

I tried to search on the forum but I found nothing; use creo/proe for several years but I practically never used sheet metal.

I should simply roll a shaped sheet;

in the sense that I have the development of the sheet (then I start already from a plate) and I want to displace it, only that I can not; I looked for tutorials around but all start from the cylinder and then flatten and never on the contrary -. -

It's probably stupid but I'm losing; I attach the stp file (I use creo 1.0 cmq)

Thank you.

 

[320i S]

Hello, question of rite, what pro-e/creo do you have?

 

[slurpix]

Hello, question of rite, what pro-e/creo do you have?

as written, use creo 1.0

 

[320i S]

Sorry, I didn't read.
the function to use, is bending.
put the bending line with the recurrences on the arrival board, but instead of leaving 90° and the fold radius = thickness, put 360° and the fold radius as much as you want the rolling.

If you have to do development checks, I suggest you go step by step on the radius of displacement, from a larger one and away approach the final radius you want.

 

[slurpix]

very kind, Monday I try, thank you!

 

[simonema2278]

Hello everyone, I have problem with solidworks 2018.
I've got a c-sheet that I'm supposed to dip but:
1) if I try starting from a revolution and trying to turn it into sheet metal does not accept it;
2) if I design the profile to c and then I try to displace it does not make me do it

Is there a simple remedy?

Thank you.

simone

 

[MassiVonWeizen]

without seeing how the file is made you can't tell which solution is

 

[MassiVonWeizen]

Moreover if you talk about solidworks do not write in the section of creo

 

[simonema2278]

Moreover if you talk about solidworks do not write in the section of creo

Sorry if I wrote here now place the file on the other discussion

 

[folle76]

very kind, Monday I try, thank you!