apply 3d model material withdrawal

[Robert Tutu]

hi to all, I would like to ask you politely how to apply the withdrawal of 1,65% to the plastic piece that I have to model, the material is latistat_52_7_02 (pp antistatic). having never done it I don't know how to proceed, I use I create 2.0
I attach image of the piece.

Thank you very much to those who will help me.
cordial greetings,

Robert

 

[mamobono]

if you have pro/mold there is the withdrawal command.
otherwise you can arrange but with some limit with the model scale command.
Look for them in the help I use wf4 and I don't know where I'm at.
careful that with model scale you lose the original file so I would make a copy _1.65 and I would apply on this scale , unfortunately it seems to me that the command does not apply on an inheritance so you will lose association between the piece and the piece with withdrawal.
I did a test and it's like this for me but you also check.

Hi.

 

[Vittorio]

hi to all, I would like to ask you politely how to apply the withdrawal of 1,65% to the plastic piece that I have to model, the material is latistat_52_7_02 (pp antistatic). having never done it I don't know how to proceed, I use I create 2.0
I attach image of the piece.

Thank you very much to those who will help me.
cordial greetings,

Robert

Try to see if this video can help you
video factor scale

 

[tomas]

but do you have to design a plastic mold? because I didn't understand for the first time what you mean, the withdrawal 1.65% then I think when you write it in the withdrawal command you have to write 1.0165...I may have misunderstood... : )