constraints do not update

[ReFazzi]

Good morning
I have a very serious problem for a couple of times:
in a completely bound assembly I made a change to a part by moving holes. the assembly did not update, in practice the part bound to the modified holes did not follow the shift.
constraints did not make mistakes. the version was inv 2010. not even the closing and reopening of inventor solved the problem.
there were no derived parts, mirrored, was not used adactivity.

my retailer analyzed the file solved me using "recreate everything" from "management" without knowing how to give me an explanation of what happened.

now I have been presented with the same problem with 2011. this is a very serious thing because working normally you can take references and do work based on components that are not in the right place.

someone noticed this problem, you know what it is generated and how it can be avoided?
for now we are forced to use the command recreates everything very often.

greetings

 

[Ilario]

Did you check if by chance, in tools -> application options, tab together there is a tick on the item "upper update"? should be disabled.

or in the standard.iam template or in the specific combination file you go to tools -> document settings, tab modeling and make sure that the "advanced processing validated" item is active (it is more likely that it is rather than before).

interesting how assistance never knows how to solve issues....

 

[ReFazzi]

Thank you
In fact on model settings I had not selected that entry, now I will send it both on the templates and on the projects I'm working on.

Is it the case to activate it on the parts?

p.
but we also work on holidays

 

[Tarkus]

Did you check if by chance, in tools -> application options, tab together there is a tick on the item "upper update"? should be disabled.

or in the standard.iam template or in the specific combination file you go to tools -> document settings, tab modeling and make sure that the "advanced processing validated" item is active (it is more likely that it is rather than before).

interesting how assistance never knows how to solve issues....

after your post I gave a check to my template: The option is deactivated and unactivated (it's gray...) can you tell me what it depends on?

p.s. assistance should attend the forum assidually...

 

[Tarkus]

Good morning
I have a very serious problem for a couple of times:
in a completely bound assembly I made a change to a part by moving holes. the assembly did not update, in practice the part bound to the modified holes did not follow the shift. ......

greetings

It happens to me too, but I just need to start moving with the muose the part, and everything updates.
Just that you have to check that the move happens... .

 

[Ilario]

after your post I gave a check to my template: The option is deactivated and unactivated (it's gray...) can you tell me what it depends on?

p.s. assistance should attend the forum assidually...

reading in the online guide says that it is not feasible if the file is "born" without and you worked like this. However, if you go to the option window and click on the ? below tells you everything.

 

[Tarkus]

reading in the online guide says that it is not feasible if the file is "born" without and you worked like this. However, if you go to the option window and click on the ? below tells you everything.

:redface: ok,graze...

 

[diegus]

Are there bolted connections in the axieme?
If you are the ones that are troublesome. if you do dx button on the connection and then compose there are options related to updating the connection itself.

 

[ReFazzi]

Are there bolted connections in the axieme?
If you are the ones that are troublesome. if you do dx button on the connection and then compose there are options related to updating the connection itself.

no, in the assemblies I do not use the bllonate connections, I bind the holes and where I need to insert a my bolt that is represented by simple parts.

Now I'm testing the lyrics

Thank you.