creation

[loste23]

Good day to all!
using creo ptc
I should create a surface from two sections that are not on parallel planes between them, about 300mm distant.
the first is parallel to plan z, the other is tilted 32°
the surface should be normal on the z floor and end on the second section floor
What command can I use?
Thank you.
Good day
steak

 

[Kotom-Eng]

I suggest using "basic loft":

Kotom-Eng

kotom.eng.free.fr

 

[loste23]

thanks for the support,
Tomorrow morning I try and let you know! !
Good evening

 

[loste23]

Hi.
I used the blend command
first direction the sections themselves, second direction two curves that connect the sections
Good day

 

[AlbeLav]

Do you have to do it with creo parametric (parametric) or with creo elements direct modelling (non parametric)?

 

[cacciatorino]

Do you have to do it with creo parametric (parametric) or with creo elements direct modelling (non parametric)?

Sorry, I was wrong to move the discussion into the forum of creo parametric. I'll fix it.

 

[Kaji]

hello but the section of your solid must remain constant, and moreover the generated surface must be "normal" both to the starting section and to the arrival section or only to the starting one?