disabled regeneration - family table

[Hope]

Hi.

do you know how to disable (temporarily) the update of variants (instances) when I make a change to the generic? work with creo 5 out windchill.

I basically have a changing box that was modeled on the generic and then 12 variants such as instances were created.
every time I make a minimum modification to the generic, like delete a section, I create part with the regeneration of all variants (it takes about 2 minutes each time).

I set up in the config enable_autoregen=no but nothing changed.

Thank you all.

 

[Hope]

I've been thinking about half a solution. I still had to test it because I didn't create a submarine.

and if I put the instances in insert mode at the beginning of the model tree? In theory I create it would try to regenerate but it wouldn't have features to process. so doing regeneration time should decrease significantly.

Let me know what you think.

 

[arni1]

I think the best way and to throw fouri from the ram all variants before changing the generic.

Hi.
hinges

 

[Hope]

hi arni, thanks for the answer.
how do you remove from the ram the variants loaded in memory? if I go on undisplayed erases (erase not displayed) tells me that I only have the generic in memory.

 

[arni1]

variants loaded in memory only let themselves be erased from the ram, if they are not in a drawing or assembly in memory.

Hi.