doubt about cosmetic thread

[gtsolid]

no step no, but the m yes

 

[MassiVonWeizen]

to me does not do it with cosmetic thread din neither with that iso

 

[gtsolid]

add m72 to the creation wizard holes?

 

[MassiVonWeizen]

add m72 to the creation wizard holes?

???

 

[gtsolid]

qualcosa type questo: stops at m62

 

[MassiVonWeizen]

What's the domanda?

 

[gtsolid]

What's the domanda?

Is it possible to add my m72 to the wizard list, since they stop at m64? in this way I do without the cosmetic thread and I find myself in the step drawing and "m"

 

[MassiVonWeizen]

as written in post #4 by adding the voice to the toolbox following the link guide of the post #9

 

[SIMONE02]

hi, can you hide a part of cosmetic thread in the middle section?
I attach image.
Thank you.

 

[MassiVonWeizen]

Something's not right. I just tried with 2014 and correctly shows only the one in the section; in your section also cosmetic thread has big line thing that is not correct.
Has the cosmetic thread been inserted with some procedure or appearing at the insertion of the view?
write the software version in the profile

 

[SIMONE02]

Thanks for the answer, I have the 2016 version. In fact it has the big line on the right because it is overlapping the line of extension of the quota g1/2. cosmetic thread has been inserted in the normal part, annotations - cosmetic thread

 

[MassiVonWeizen]

pass the view from quality draft to high quality

 

[SIMONE02]

pass the view from quality draft to high quality

Thank you very much

 

[gtsolid]

hi, I added the parameters in the toolbox but quotating in the table does not appear the correct quota:

 

[MassiVonWeizen]

an external thread is placed on the outer diameter and not on the thread line.
an internal thread is listed on the thread line and not on the hole diameter.

 

[gtsolid]

I didn't know.
As you say, I have the symbol of ø:

 

[MassiVonWeizen]

Oh, non-pevo.

very bad for a designer.

As you say, I have the symbol of ø

because solid in external threads does not recognize the thread because you select the solid while in the case of holes you select the cosmetic thread. It's an old problem.

 

[gtsolid]

I understand. Thank you.