drain on edge

[LucaP79]

Good morning.
I find myself having to make an edge on the upper edges of a box, folded inside. see image attached
I tried to use the edge command, but the 2 created edges intersect on the inner side and in no way I managed to create the discharge, (also with the custom drain).
Meanwhile I had to use a 179° edge flange even if it does not match reality.
in the manual that I attach the photo it is written to set the " corner cut game ", parameter that I do not find anywhere.
Does anyone have any suggestions?? I don't think it's a version problem (I use 2015) as the manual page is the same as the 2020 version.

Thank you.

 

[MassiVonWeizen]

the game on the edge you get when you do the function on the same face of the sheet metal

 

[LucaP79]

the game on the edge you get when you do the function on the same face of the sheet metal

Thank you for the answer, so with the command I deduce that I can't fix. . Do I have to leave a flange of the edge at 179°?? or is there any more "intelligent" way? ? !

 

[MassiVonWeizen]

How is the solution you got? Can you attach the file?

 

[+forte]

Good morning.
I find myself having to make an edge on the upper edges of a box, folded inside. see image attached
I tried to use the edge command, but the 2 created edges intersect on the inner side and in no way I managed to create the discharge, (also with the custom drain).
Meanwhile I had to use a 179° edge flange even if it does not match reality.
in the manual that I attach the photo it is written to set the " corner cut game ", parameter that I do not find anywhere.
Does anyone have any suggestions?? I don't think it's a version problem (I use 2015) as the manual page is the same as the 2020 version.

Thank you.

traduci da http://help.solidworks.com/2018/english/solidworks/sldworks/hidd_sm_hem.htm?verredirect=1
in italianohttp://help.solidworks.com/2018/italian/solidworks/sldworks/hidd_sm_hem.htm?verredirect=1

 

[LucaP79]

attached the file...

 

[MassiVonWeizen]

Meanwhile I can tell you that making holes with sketch repetition is a suicide in terms of performance.
the repetition of the function is much leaner; Moreover it has the advantage that in a table you can temporarily suspend the repetitions to complete the design and reactivate them only at the end.
I can tell you that, on my pc and with 2019, your version takes 3 seconds of regeneration of the part while with the repetition of the function takes 2 seconds; seems little, but in other contexts (axioms and tables) this difference makes you feel

 

[MassiVonWeizen]

I found this discussion that deals with your same problemhttps://forum.solidworks.com/thread/52385You know what?

 

[LucaP79]

I found this discussion that deals with your same problemhttps://forum.solidworks.com/thread/52385You know what?

thanks for the concern to the problem and the data advice, I believe that my solution eventually is the best as it approaches more to the required target.

Good evening.