geometric tolerances

[Christian_spinelli]

Hello everyone,
I have a problem with proe wf3; if I impose an axis as a reference for a geometric tolerance, then, in the table, I appear in all the views in which I show the axis.
How can you make it appear only where I want?
Thank you.

 

[maxopus]

you can select the views and hide in these the axle layer

 

[Christian_spinelli]

Thank you very much.
but if I want some references and not others in that view?

 

[maxopus]

What do you mean by references?

 

[Christian_spinelli]

in the attached file, for example, I would like to see the reference y in the right view and the reference x in the left view.
using levels would not be possible, right?

 

[Christian_spinelli]

raise the problem, how do I put the tolerance vertically?

 

[calacc]

in the attached file, for example, I would like to see the reference y in the right view and the reference x in the left view.
using levels would not be possible, right?

from what little I learned in this period, if you create a reference for a geometric tolerance of def. appears on all views. to eliminate it in the views where you do not need I went into the annotated tab, then in the drawing tree you can notice that for each view the reference created. All you have to do is right-click in the views where you don't want me to appear.
p.s. erases, does not eliminate otherwise it takes you everywhere

 

[calacc]

I don't know what you mean

raise the problem, how do I put the tolerance vertically?

 

[Christian_spinelli]

you know that the indication of tolerance, such as 0.1 parallelism with reference to can be read both horizontally and vertically. I want to know how to put it vertically