impossible to extrude

[DilanDesign]

Bye to all,

I am trying to perform an extrusion to create a plate starting from a sketch made half by a projection and the other half by simple lines, the problem is that when I start the command already the extrusion part highlighted of red therefore some problem there is for sure, at the end of the command appears the written "crea extrusion: detected problems during the execution of this command.

thanks to the pious soul that will help me! :wink:

 

[TECNOMODEL]

open sketch?

 

[DilanDesign]

I tried in both cases

 

[Tarkus]

Did you try to pass the sketch to the closed line command?

 

[TECNOMODEL]

if you place the file you can take a look

 

[DilanDesign]

as not said, the error was in creating the sketch directly on geometry instead that create a new component and then go to project the underlying geometries!

Thank you!