inclined plane representation

[Melman89]

Hello everyone, I have a little problem with a table.
the particular is composed of simple geometries but presents in the upper part a double inclination, how should I represent it?
I can't figure out how I have to quote the high part... I hope someone can give me some disappointments.
I thank in advance all those who will give me an explanation.

 

[MassiVonWeizen]

with auxiliary views as from image.
But not using I create I have no idea what commands you should use, if that's your question.

 

[Melman89]

the question was not related to how to do it in creo, it was just at the level of views because I do not understand how to indicate the various inclinations, because if I had to do it with a frieze I do not know how to indicate them.
another thing, if at the holes in the top, you want to give references to the low hole, how could I do?

 

[MassiVonWeizen]

the question was not related to how to create

you opened the discussion in the I create section so you think the subject of the problem is the software.

I don't understand how to indicate the various inclinations, because if I had to do it with a milling mill I don't know how to tell them.

as indicated in the image.

If at the holes in the upper part, you want to give references to the low hole, how could I do?

quotating the center of the holes on the external face (the one from where the tip will enter) on the axes x, y and z

 

[Melman89]

Thank you so much for the answers!