inv2017 - automatic thread in the views

[alex.marsetti]

Good morning.
I would like to ask you for help on a problem with the views of inventor 2017.

In practice when I create a view on the table I must every time set that thread is active.
If by mistake I forget, inventor no longer updates my view and I have to do it again.Is there a way to ensure that the "filettatura" check is already set by default?
the problem is serious, because the drawings go to the workshop and the holes seem to pass rather than threaded.

thanks to those who want to answer.

 

[stefanobruno]

It is not true that you cannot reset the view of the thread, just double click on the view that interests you and, from the tab "display options ", snacks " thread ".
I do not understand that it is possible to set it by default, it is a choice of autodesk not to increase exponentially the times of the masses in the table of great assemblies.

 

[alex.marsetti]

Good morning stefanobruno,
yes your answer is correct, the problem is that I double-click it, re-imposed "filettatura" and stick it, then in fact the view does not update and I remain the holes without representation.
I guess it's an inventor's problem at this point, but I don't know how to solve it. . .

in the inventor 2015 it was possible to set it by default by changing a registry key, but with the inventor 2017 I no longer find that key.

 

[dicifa]

try to reuse the same registry key. . .

 

[Ilario]

Good morning stefanobruno,
yes your answer is correct, the problem is that I double-click it, re-imposed "filettatura" and stick it, then in fact the view does not update and I remain the holes without representation.
....

question: Are you sure that view, in which you say that threads are not seen, is "perpendicular" on the plane on which the threaded holes are present? because if the view is also only slightly inclined to the top of the sheet, the threaded holes will not be seen "correctly".

 

[alex.marsetti]

the registry key is no longer the same as the inventor 2015 and the organization has changed.

I am rather curious to deepen the answer of the Ilario.
in what sense if it is not perfectly perpendicular to the plane, the holes are not seen correctly?
In theory they should see each other equally. . .
I'll get you an image of the situation. . .

 

[Ilario]

to see the view so I would say that's not the case... I was referring more to the view in the plant. I can't help you then.. .

 

[alex.marsetti]

thank you for the ilary answer, excuse me for the delay but the mail of your answer had ended me in spam... ;-)