nx performance on open for large numbers of unique parts

[The_Matrix]

I turn you an interesting sfb (software field bullettin).
s o f t w a r e sfb-nx-5601
f i e l d page 1 of 1
b u l l e t i n issue date: september 22 2010
revision date: n/a
supersedes: n/a
submitted by: stewart bresler
responsible group: nx
gtac 800 # options(s): 2,1

product: nx
subject: nx performance on open for large numbers of unique parts
----------------------------------------------------------------------------
affected software: nx
associated pr number(s): ir 1789566
scope: nx 6.0.3 and higher
revision: n/a
----------------------------------------------------------------------------


problem:

a performance problem has been detected in nx 6.0.3 (or higher) when
opening assemblies having a large number of unique parts in the first level
of the assembly. the performance problem is caused by using
the “modifiable” column in the nx assembly navigator.

remedy:

turn off the “modifiable” column:
- start nx
- open any part
- in the assembly navigator turn off the “modifiable” column
users can use the “read-only” column in the nx assembly navigator to deduce
similar information.

this problem will be addressed in a future release of nx and teamcenter.

 

[IPdesign]

So one using a 6.02 should be exempt??

 

[The_Matrix]

So one using a 6.02 should be exempt??

Right... .