post processor visi 15 haas automation vf

[neverste]

Good morning to all, I just signed up and used just visi15 of the truth to perform work on the work center haas automation vf 3 axes.
I wanted to hope if it was possible to recover files to postprocess paths on this type of control? Thank you all!

 

[rinato]

hi, it depends on which language you have to recover files. if you mean you have dwg/dxfs typical of autocad, in visi you have to import them with the appropriate command of the file menu ( visi has a proprietary format ).
If you mean instead that you already have block/cn files written for another machine there should still be a revpost utility to recover or as geometry or as a tool path your old cn files, but I think you will have to take it from your dealer. I say it should because the visi is at v18.
Say hi.

 

[neverste]

hi, it depends on which language you have to recover files. if you mean you have dwg/dxfs typical of autocad, in visi you have to import them with the appropriate command of the file menu ( visi has a proprietary format ).
If you mean instead that you already have block/cn files written for another machine there should still be a revpost utility to recover or as geometry or as a tool path your old cn files, but I think you will have to take it from your dealer. I say it should because the visi is at v18.
Say hi.

I am not very experienced but I think I have recovered the file! anyway thank you.. .