quotas visible only to a certain scale

[Piron88]

Hello, everyone.
I wondered if it is possible in autocad to make sure that certain objects can be visible only in a certain scale of the layout window. I explain better: in an architectural drawing board I have quotas on a single layer called "quote". some of these odds I want you to see only in the 1:200 scale layout window, while other odds I want you to see in the 1:100 scale layout window.
same also for some block references.
Is it possible for you to do it with autocad??
Thank you.

 

[sircame]

if you use various fines for each window you can exclude its layers.
if in window 1 I have 1:100 scale drawing I hold the quota layer active.
if in window 2 I have the 1:200 scale drawing I turn off the layer quotas.

But turn off the whole layer, if you want a partial thing, you should create more layers.

if the blocks are on different layers (not content, but block by itself) you can do the same thing.

 

[Tristan]

Of course it's possible! better documented on annotative objects
http://exchange.autodesk.com/autoca...ws1a9193826455f5ff1bb1a0510dab2fb04a-7f63.htm