quotature problem

[Paco87]

I have made a 3d model of rectangular shape and small thickness, a sheet, there is a straight axle. in the table when I put the quotas it makes me insert them all without problems except that of the radius/diameter of the asola, in practice when I select the command of quota it makes me see the quota, but when I click to confirm it does not remain on the drawing.
I hope I've been clear.

 

[Ivan1990]

I have made a 3d model of rectangular shape and small thickness, a sheet, there is a straight axle. in the table when I put the quotas it makes me insert them all without problems except that of the radius/diameter of the asola, in practice when I select the command of quota it makes me see the quota, but when I click to confirm it does not remain on the drawing.
I hope I've been clear.

you have to go into general options> ownership of the document>lines/ and select images with the axes of the sunshades in the center.

 

[Paco87]

Thank you very much.

 

[Mike1967]

I have made a 3d model of rectangular shape and small thickness, a sheet, there is a straight axle. in the table when I put the quotas it makes me insert them all without problems except that of the radius/diameter of the asola, in practice when I select the command of quota it makes me see the quota, but when I click to confirm it does not remain on the drawing.
I hope I've been clear.

the second click (to place the quota), do it out of the piece you are measuring.
can be that the piece does not have a "normal" view and therefore creates that problem.
If anything you do a/two view projection and make sure it is not slightly rotated.