service pack 1 inventor 2012

[Peppe]

finally we're discarding e vediamo.....

 

[ReFazzi]

Finally! ! !
this sp has solved a problem on the interface of choice of faces with constraints.
reported also at tarkus (http://www.cad3d.it/forum1/showthread.php?t=27441).
unless they've "come" something else seems to be okay
greetings

 

[Peppe]

as far as I am concerned, I must say that this s.p. has really set up a lot of problems...... luck ^________________________________________________________________________________________________________________________________________________________________________________________________________________

 

[reb_bl]

we installed yesterday, inventor 2012... luckily there was the sp1! !

 

[ReFazzi]

with the sp1 to me disappeared preview of the axles when I have to project them, you see only the extreme points but not the axes. fx 1800 drivers are up to date.
Does anyone else have the same problem?

 

[Peppe]

with the sp1 to me disappeared preview of the axles when I have to project them, you see only the extreme points but not the axes. fx 1800 drivers are up to date.
Does anyone else have the same problem?

I confirm, it does to me even if I have to bind, at the time of the selection of the axis you see only the extreme points but not the axis....

 

[Tarkus]

Finally! ! !
this sp has solved a problem on the interface of choice of faces with constraints.
unless they've "come" something else seems to be okay
greetings

I confirm, it does to me even if I have to bind, at the time of the selection of the axis you see only the extreme points but not the axis....

in fact, they fixed something and bought something else...