toolbox diameter

[MARCOC]

good morning to all,I am always in the grips with the toolbox,I have to add a dimension to the screws the m14 that does not exist in the list of iso 4017,so that in the insertion of the data asks me 2 values that absolutely do not know what they are
I'll put on a picture
Can anyone help me? ? ?

we are talking about hexagonal screws, what do the lamatures do? ? ?

Thank you very much

 

[meccanicamg]

You can still cash it... so it takes all the parameters.
it's a little bit slender to manage the toolbox for holes.... But better than that they did not.

 

[MARCOC]

mechanical excuse, but what does "can still cash" and in the end what value I have to put on that box, there is no indication of what that quota means

Can you do a sketch to figure out what that diameter refers to? ? ?

 

[MassiVonWeizen]

Don't you know you can cash out a hexagonal nut too?

 

[MARCOC]

I understood mechanics, "you can still cash out the hexagonal head" as if it were a caterpillar
then that is referred to the tips of the hexagon right? ? ?

 

[MassiVonWeizen]

and how do you block the head of the screw?

 

[MARCOC]

we wrote one on the other before
What do you mean for your last post?? What do you have to block? ? ?

 

[MARCOC]

I believe that the diameter you want in the toolbox table is related to the only pass of the headI took the m16 data that there are the tables
I mean, I don't know. ? ? ?

 

[MassiVonWeizen]

What do you have to block? ?

come la blocchi la head of the screw?

or more precisely how do you tighten if the nut or the head of the screw do not hold it steady? If on the other side the hole is blind as you turn the screw?

 

[MARCOC]

with a compass, but I do not understand what centea does this with the initial question, I had to understand what the diameter is rofetivated and I believe thanks to the input of mechanics of having understood what they refer to (see 2 attached image) you agree massive? ? ?

 

[MassiVonWeizen]

It is spectacular as you are always present to ask for clarifications and solutions, but as soon as you get what you need, you have chronic memory blanks (I don't refer to this post).
for this post, in my opinion, you have all the information necessary to reason about the solution and find it alone

 

[MARCOC]

Massive, but tell me what center that you wrote with question of the post,nom I can understand what you mean, what center how you hold the screw with the diameter of lamatura? ? ?

 

[MARCOC]

mechanics, confirm that the diameter of lamatura and what I hypothesized with image 2 after your suggestion? ?